Harley-Davidson Evolution Engines, Hydraulic Lifter Limited Travel Kit...
download Remove tappet assemblies from engine being sure that each one is kept with it’soriginal tappet block. NOTE: This procedure is the preferred method of installation. However, kit can be...
View ArticleHI-4 DUAL FIRE MOTORCYCLE IGNITION INSTALLATION INSTRUCTIONS
download Turn ignition switch off and disconnect battery ground cable. 2. Refer to Figure 3. Remove OE ignition module and wire harness (items 1-4). You will disconnect two wires at the coil (15), a...
View Article8950 and 8960 Series High Performance Tire Changer Operation Manual
download GENERAL CAUTIONS A. DURING THE USE AND MAINTENANCE OF THE MACHINE IT IS MANDATORY TO COMPLY WITH ALL LAWS AND REGULATIONS FOR ACCIDENT PREVEN- TION. B. THE ELECTRICAL POWER SOURCE MUST HAVE A...
View ArticleHARLEY-DAVIDSON BIG TWINS COMPUFIRE 1084 GEAR SETS INSTALLATION INSTRUCTIONS
download 1. Remove the seat and disconnect the cables at the battery. Remove the ground cable first and then the positive (+) cable. 2. Drain the oil in the outer primary case and remove the outer...
View ArticleTwin Tec Installation Instructions for TC88A-IH Ignition
download INSTALLATION ON 2004 MODELS 1. Turn off the ignition switch and disconnect the battery ground cable before proceeding. 2. Refer to Figures 2 and 3 for wiring details. 3. Remove the Gill...
View ArticleHarley-Davidson Vacuum Operated Switch Kit Installation MANUAL
download 1. Turn off the ignition switch and disconnect the battery ground cable before proceeding. 2. For applications with Harley-Davidson OE ignition modules, simply replace the existing OE VOES...
View ArticleHarley-Davidson Twin Cam Engines Cam Chain Drive System Installation and...
download Removing the Cam Chain Drive System. NOTES Changing camshafts and cam drives in the 2006-up Harley-Davidson® Twin Cam 88® engines is different than in pervious engines. Procedures require use...
View ArticleHARLEY-DAVIDSON 1979-Later Big Twin CONVERSION INSTALLATION MANUAL
download Turn ignition switch to the OFF position. Disconnect the ground cable from the battery. 2) Disconnect the wire at the coil which runs down to the points. Remove the point cover plate. 3) Note...
View ArticleHarley-Davidson Electronic Ignition Module Installation instructions
download Step 1: Switch main dashboard switch to “off” position (Ignition& light switch) Step 2: Disconnect negative (ground) cable from the Battery Step 3: Remove the Condenser and Breaker points...
View Article
More Pages to Explore .....